TM-9-2815-210-34-2-2

ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER

TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2

APRIL 1981

TM-9-2815-210-34-2-2 - Page 632 of 968

TM 9-2815-210-34-2-2

FRAME 2

WARNING

Do not use less than six universal mounting arms.

Using less than six arms may cause cylinder block to

fall, causing damage to equipment and injury to personnel.

NOTE

Capscrews used to mount cylinder block accessories will be

used to mount cylinder block to maintenance stand. Universal

mounting arms will be placed as far apart as practical

at various angles.

Do not tighten capscrews until all

screws are put in.

1.

Working on crank side of maintenance stand, put two universal

arms (1) in place on mounting plate (2). Put in two cap screws

2.

Put two L-shaped brackets (4) in place on cylinder block (5).

3.

Put in two capscrews (6).

GO TO FRAME 3

and

cap-

mounting

(3).

5-3