TM-9-2815-210-34-2-2

ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER

TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2

APRIL 1981

  TM-9-2815-210-34-2-2 - Page 640 of 968

TM 9-2815-210-34-2-2
FRAME 3
NOTE
The number four main bearing lower half (1) is called
thrust main bearing lower half. It is different from other
main bearing lower halves because it has flanges (2).
1.
Coat thrust main bearing lower half (1) with oil on both sides.
NOTE
The number four main bearing cap (3) is called thrust
main bearing cap. It is different from othe r
ing caps because it has a thrust shoulder (4).
2.
Put thrust main bearing lower half (1) into thrust main bearing cap (3).
3.
Put thrust main bearing cap (3) in place on engine block (5). Put in two
cap screws with washers (6). Do not use torque wrench at this time.
GO TO FRAME 4
5-11


Back to Top