TM-9-2815-210-34-2-2

ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER

TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2

APRIL 1981

TM-9-2815-210-34-2-2 - Page 648 of 968

TM 9-2815-210-34-2-2

FRAME 11

1.

2.

3.

4.

5.

Coat both sides of gasket (1) with sealant. Put gasket in place on cylinder

block (2).

Put engine front plate (3) in place. Put in and tighten six screws with lock-

washers (4).

Coat front main bearing cap (5) and lower main bearing half (6) with oil. Put

main bearing half into main bearing cap.

Put front main bearing cap (5) in place in cylinder block (2). Put in two

cap screws with washers (7).

Tighten two capscrews to 80 to 90 pound-feet.

Tighten two cap screws (7) to 120 to 125 pound-feet.

END OF TASK

5-19