TM-9-2815-210-34-2-2

ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER

TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2

APRIL 1981

TM-9-2815-210-34-2-2 - Page 646 of 968

TM 9-2815-210-34-2-2

FRAME 9

1.

2.

3.

CAUTION

Main bearing lower halves and main bearing caps were

marked during removal.

They must be put back in the same

position and facing the same way. Failure to do this will

result in damage or wear to engine.

Coat four main bearing caps (1) and four main bearing lower halves (2) with

oil.

Put four main bearing lower halves (2) into four main bearing caps (1). Put

four main bearing caps into cylinder block (3). Put in eight cap screws with

washers (4).

Tighten eight capscrews (4) to 80 to 90 pound-feet. Tighten eight capscrews

to 120 to 125 pound-feet.

GO TO FRAME 10

5-17