TM-9-2815-210-34-2-2

ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER

TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2

APRIL 1981

TM-9-2815-210-34-2-2 - Page 653 of 968

TM 9-2815-210-34-2-2

5-7. CRANKSHAFT REAR OIL SEAL AND HOUSING.

FRAME 1

1.

2.

3.

4.

Put crankshaft rear oil seal housing (1) on arbor press table (2), Gasket

surface of rear oil seal housing should face down as shown.

Lightly coat oil seal (3) with lubricating oil.

Start oil seal (3) into crankshaft rear oil seal housing (1) by hand. Oil

seal lip (4) should face down as shown.

NOTE

Square, flat metal plate may be used instead of round

pressing arbor (5).

Plate must be bigger than diameter

of oil seal (3).

Using pressing arbor (5) with diameter larger than outside diameter of oil

seal (3), press oil seal all the way into crankshaft rear oil seal housing (1).

GO TO FRAME 2

5-24