TM-9-2815-210-34-2-2

ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER

TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2

APRIL 1981

TM-9-2815-210-34-2-2 - Page 700 of 968

TM 9-2815-210-34-2-2

5-14. FLYWHEEL HOUSING.

a.

Replacement.

FRAME 1

1.

Put gasket (1) on rear of crankcase assembly (2).

2.

Put flywheel housing (3) on crankcase assembly (2).

3.

Coat threads of two studs (4), threads and seats of two nuts (5), and two

1/8-inch thick flat washers (6) with engine oil.

4.

Put nut (5) with 1/8-inch flat washer (6) on each of two studs (4). Hand

tighten nuts.

5.

Coat threads of six studs (7), threads and seats of six nuts (8), and six

1/16-inch thick flat washers (9) with engine oil.

6.

Put nut (8) and 1/16-inch flat washer (9) on each of six studs (7). Hand

tighten nuts.

GO TO FRAME 2

5-71