TM 9-2815-220-24
INDUCTION LEAK TEST
0037 00
TEST (Continued)
NOTE
Some air escaping past the rings and from vents will be heard.
2. Leaks in the induction system may be detected by using water and soap solution at all joint
areas.
3. If leaks are found, remove air supply and repair leaks.
Refer to the appropriate section in this
manual for repair.
4. Repeat steps 1, 2 and 3 until all leaks are repaired.
Air Supply
6
5
4
AFTER TEST
1. Remove air supply and regulator assembly (6).
2. Remove turbosupercharger covers (4 and 5).
WP 0037 00-3