TM 9-2815-220-24
GENERATOR REPLACEMENT (300 AMPHERE)
0052 00
INSTALLATION (Continued)
CAUTION
It is of utmost importance that the generator support, cradle, and
U-bolt be installed in a manner that will not disturb generator
mounting alignment and still furnish adequate support to minimize
vibration.
Misalignment of 0.010 inch in any direction is sufficient to
cause a leak (pressure loss) between the generator mounting flange
and the generator mounting adapter. Follow the procedure to assure
alignment and proper support.
6. Loosely assemble cradle (27) to bracket (32) allowing cradle to move freely in elongated
holes.
7. Position the assembled generator cradle (27) and bracket (32) on the oil pan.
a. Secure using four bolts (33) with flat washers (34).
Tighten bolts only until heads engage
washers (finger tight).
b. Install U-bolt (30) over generator and secure using self-locking nut (28) and clamping
bar (29).
c. Tighten two screws (31) securing cradle (27) to support (32).
d. Tighten four screws (33) securing support.
33, 34 (4 places)
29
30
31 (2 places)
27
28
32
WP 0052 00-8