TM 9-2815-220-24
WIRING HARNESS AND CABLE REPAIR
0056 00
REPLACEMENT OF CONNECTORS (Continued)
Disassembly of Terminal Type Cable Connectors
1. Cut and discard terminal (A).
Assembly of Terminal Type Cable Connectors
1. Strip cable (B) insulation equal to depth
of terminal well.
C
B
A
2. Slide insulator (C) over cable (B).
3. Insert cable (C) into terminal (A) well
and crimp.
4. Slide insulator (C) over crimped end of
terminal (A).
Disassembly of Female Cable Connector with Washer
1. Cut and discard terminal (A).
Assembly of Female Cable Connector with Washer
1. Strip cable (B) insulation approximately
1/8 inch (3.2 mm).
A
D
C
B
2. Slide shell (C) and washer (D)
over cable (B).
3. Place cable (B) in cylinder end of
terminal (A).
4.
Slide shell (C) and washer (D) over
terminal (A).
Disassembly of Male Cable Connector with Washer
1. Cut and discard terminal (A).
Assembly of Male Cable Connector with Washer
1. Strip cable (B) insulation equal to depth
of terminal (A) well.
A
C
B
D
2. Slide shell (C) over cable (B).
3. Insert cable (B) into terminal (A) well
and crimp.
4. Place C-washer (D) over cable (B) at
crimped junction and slide shell (C)
over C-washer (D) and terminal (A).
WP 0056 00-14