TM 9-2815-220-24
CYLINDER OIL DRAIN TUBES REPLACEMENT
0077 00
INSTALLATION (Continued)
6. Assemble right bank oil drain tube assembly (18).
a. Lubricate inside of new hoses (22) (item 313, WP 0175) with lubricating oil (item 21,
WP 0173).
b. Place clamp (21) on inboard end of tube (23) and position towards fluid passage bolt hole
to allow installation of hose (22).
c. Install hose (22) on inboard end of tube (23) and position it half way onto tube.
d. Place clamp (22) on [inter-cylinder] tube (24) and position it towards fluid passage bolt
hole.
e. Insert tube (23) half way into opposite end of hose (22).
f.
Repeat procedure for remaining inter-cylinder tubes (22) and end tube (25), leaving
clamps (22) loose.
7. Install right bank oil drain tube assembly (18) onto engine.
a. Position a new lubricated gasket (20) (item 283, WP 0175) top and bottom of each tube
(23, 24, 25) and secure at each cylinder with a fluid passage bolt (19).
b. Center hoses (22) at each location and secure with clamps (21).
c. Torque-tighten fluid passage bolts to 275-300 inch-pounds (31-34 N•m).
DAMPER END
RIGHT BANK
16
18
19
20
FLYWHEEL END
22
21
11
7
5
25
24
23
WP 0077 00-10