TM-9-2815-224-34-P

ENGINE, DIESEL:8-CYLINDER TURBOCHARGED, DETROIT DIESEL CORPORATION MODEL 8V92TA

DIRECT SUPPORT AND GENERAL SUPPORT MAINTENACE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST

JANUARY 1988

TM-9-2815-224-34-P - Page 369 of 554

TM 9-2815-224-34&P

Blower Maintenance Instructions (Cont)

(72)

Install rear end plate

cover (39) with gasket (40).

NOTE

Some blowers have ten screws and

lockwashers. Others have nine screws and

lockwashers.

(73)

Install nine or ten screws (41)

and lockwashers (42).

(74)

Tighten screws (41) evenly to

15 lb-ft (20 N•m).

NOTE

Some engines are equipped with a bypass valve on

the blower. If equipped with bypass valve, do

steps

(75)

through

(83).

If not, go to Follow-on

Maintenance.

(75)

Install preformed packing (43) on

bypass valve (44).

(76)

Install bypass valve (44) until fully

seated.

(77)

Install pressure clamp (45) on bypass

valve (44).

(78)

Install two screws (46) in pressure

clamp (45). Tighten screws 23 to 26

lb-ft (31 to 35 N•m).

(79)

Install two clamps (47 and 48) on

hose (49).

WARNING

Adhesives solvents, and sealing compounds can burn easily, can give off harmful

vapors, and are harmful to skin and clothing. To avoid injury or death, keep away

from open fire and use in well-ventilated area. If adhesive, solvent, or sealing

compound gets on skin or clothing, wash immediately with soap and water.

(80)

Apply sealing compound on threads of hose fitting (50).

(81)

Install hose fitting (50) securely in position as noted during disassembly.

(82)

Install hose (49) on bypass valve (44) and hose fitting (50).

(83)

Position clamps (47 and 48) over hose (49) on bypass valve (44) and hose fitting (50).

d. Follow-on Maintenance.

None.

END OF TASK

Change 2

14-35