TM-9-2815-225-34-P

ENGINE, DIESEL: 6 CYLINDER IN-LINE TURBOCHARGED, CUMMINS MODEL NTC-400

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST

JULY 2005

TM-9-2815-225-34-P - Page 140 of 736

Figure 7. Accessory Drive Housing Removal.

TM 9-2815-225-34&P

0010 00

0010 00-10

ENGINE ACCESSORIES REMOVAL (Contd)

ACCESSORY DRIVE HOUSING

1.

Remove five bolts (4), accessory drive housing (3), and gasket (2) from front gear cover (1).

Discard gasket (2).

2.

For accessory drive housing assembly repair, refer to WP 0029 00.

OIL PUMP

NOTE

Perform steps 1 through 6 for Big Cam III.

1.

Remove two screws (16), lockwashers (15), and washers (14) securing oil suction tube (13) to oil

pan (20). Discard lockwashers (15).

2.

Remove two screws (17), lockwashers (18), washers (19), and oil suction tube (13) from oil pan

(20) and oil pump (7). Discard lockwashers (18).

3.

Remove two O-rings (12) and one gasket (11) from oil suction tube (13). Discard O-rings (12) and

gasket (11).

4.

Remove oil transfer tube (8) from oil pump (7) and cylinder block (5).

5.

Remove five bolts (9) and lockwashers (10) securing oil pump (7) to accessory drive housing (21).

Discard lockwashers (10).

6.

Remove oil pump (7) and gasket (6) from accessory drive housing (21). Discard gasket (6).

2

4

3

1