TM-9-2815-225-34-P

ENGINE, DIESEL: 6 CYLINDER IN-LINE TURBOCHARGED, CUMMINS MODEL NTC-400

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST

JULY 2005

TM-9-2815-225-34-P - Page 138 of 736

TM 9-2815-225-34&P

0010 00

0010 00-8

ENGINE ACCESSORIES REMOVAL (Contd)

AIR COMPRESSOR

NOTE

Big Cam III is shown. Big Cam I is similar.

1.

Remove coolant inlet tube (11), coolant outlet tube (4), two bushings (3), and elbow (2) from air

coolant adapters (1) and (12). Discard bushings (3).

2.

Remove coolant inlet tube (11), coolant outlet tube (4), two bushings (3), and two adapters (5)

from air compressor (6). Discard bushings (3).

3.

Remove two air inlet hose clamps (8) and air inlet hose (9) from air compressor (6) and elbow (7).

4.

Remove elbow (7) from cylinder block (10).

5.

Using air compressor wrench, remove two bolts (21) and lockwashers (20) securing air

compressor (6) to accessory drive housing (13). Discard lockwashers (20).

6.

Remove two nuts (19), lockwashers (18), washers (17), and bolts (14) securing air compressor (6)

to accessory drive housing (13). Discard lockwashers (18).

7.

Remove air compressor (6) from accessory drive housing (13).

NOTE

Gasket and drive coupling may remain on air compressor or

accessory drive housing during removal.

8.

Remove gasket (16) and drive coupling (15) from air compressor (6) or accessory drive

housing (13). Discard gasket (16).

9.

For air compressor repair, refer to WP 0031 00.