TM-9-2815-225-34-P

ENGINE, DIESEL: 6 CYLINDER IN-LINE TURBOCHARGED, CUMMINS MODEL NTC-400

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST

JULY 2005

TM-9-2815-225-34-P - Page 136 of 736

TM 9-2815-225-34&P

0010 00

0010 00-6

ENGINE ACCESSORIES REMOVAL (Contd)

FUEL PUMP AND FUEL LINES (Contd)

13.

Remove bolt (6) and lockwasher (7) securing support bracket (9) to cylinder head (8). Discard

lockwasher (7).

NOTE

Perform step 14 for Big Cam I only.

14.

Using air compressor wrench, remove four bolts (5), washers (4), support bracket (9) securing and

fuel pump (12) to air compressor (1).

NOTE

Perform steps 15 and 16 for Big Cam III only.

15.

Using air compressor wrench, remove bolt (13) and washer (14) securing fuel pump (12) to air

compressor (1).

16.

Remove three bolts (11), washers (10), and support bracket (9) securing fuel pump (12) to air

compressor (1).

17.

Using a soft-sided mallet, tap fuel pump (12) lightly to remove from air compressor (1).

NOTE

Gasket and spider coupling may remain on air compressor or

fuel pump during removal.

18.

Remove gasket (2) and spider coupling (3) from air compressor (1) or fuel pump (12). Discard

gasket (2).

19.

For fuel pump repair, refer to WP 0033 00.