TM-9-2815-225-34-P

ENGINE, DIESEL: 6 CYLINDER IN-LINE TURBOCHARGED, CUMMINS MODEL NTC-400

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST

JULY 2005

TM-9-2815-225-34-P - Page 127 of 736

TM 9-2815-225-34&P

0009 00

0009 00-5

MOUNTING ENGINE ON MAINTENANCE STAND (Contd)

NOTE

Perform steps 21 through 23 for Big Cam I only.

21.

Remove screw (23) and lockwasher (17) securing oil cooler support bracket (18) to cylinder block

(14). Discard lockwasher (17).

22.

Loosen clamp (16) and remove water transfer hose (15) from oil cooler (22).

23.

Remove five screws (19), lockwashers (20), oil cooler (22), and gasket (21) from cylinder block (14).

Discard lockwashers (20) and gasket (21).

NOTE

Perform steps 24 and 25 for Big Cam III only.

24.

Remove two screws (27), lockwashers (28), and washers (29) securing rear of oil cooler (30) to

cylinder block (14). Discard lockwashers (28).

25.

Remove six screws (26), lockwashers (25), oil cooler (30), and gasket (24) from cylinder block (14).

Discard lockwashers (25) and gasket (24).

26.

For oil cooler (30) or (22) repair, refer to WP 0021 00.

Figure 7. Oil Cooler Removal.

26

14

15

16

18

19

20

21

22

24

23

25

25

27

28

29

30

17

20

20

19