TM-9-2815-225-34-P
ENGINE, DIESEL: 6 CYLINDER IN-LINE TURBOCHARGED, CUMMINS MODEL NTC-400
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST
JULY 2005
TM-9-2815-225-34-P - Page 80 of 736
TM 9-2815-225-34&P
0007 00
0007 00-2
BIG CAM I ENGINE REMOVAL (Contd)
1.
Position and secure suitable transmission jack under transmission (3). Ensure transmission
weight is supported by transmission jack.
2.
Remove flywheel bolt access cover screw (8) securing breather tube clamp (9) to flywheel
housing (6) and position breather tube clamp (9), and breather tube (10) away from flywheel
housing (6).
3.
Remove flywheel bolt access cover screw (8) and flywheel bolt access cover (11) from flywheel
housing (6).
NOTE
Rotate engine using accessory drive pulley nut to gain access to
flywheel bolts.
4.
Remove twelve flywheel bolts (1) and washers (2) securing ring gear (5) to flywheel (4) through
flywheel bolt access hole (7).
5.
Loosen two lower alternator screws (12) securing alternator (30) to alternator mounting bracket
(27).
6.
Remove alternator bolt (25), washer (24), and nut (13) securing alternator (30) to alternator
adjusting rod block (23).
7.
Remove alternator adjusting rod bolt (18), lockwasher (17), washer (16), alternator adjusting
rod (20), alternator adjusting rod block (23), three alternator adjusting rod nuts (21) and two
washers (22) as an assembly, from engine (14). Discard alternator adjusting rod lockwasher (17).
NOTE
Rotate alternator in towards engine to allow for clearance
during engine removal.
8.
Rotate alternator (30) in towards engine (14) and tighten two lower alternator screws (12) to
retain alternator (30) in position.
9.
Remove two belts (19) from alternator pulley (26) and crankshaft pulley (15). Discard belts (19).
10.
Remove two lower alternator screws (12), nut (28), washer (29), and alternator (30) from
alternator mounting bracket (27).
Back to Top
