TM-9-2815-225-34-P
ENGINE, DIESEL: 6 CYLINDER IN-LINE TURBOCHARGED, CUMMINS MODEL NTC-400
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST
JULY 2005
TM-9-2815-225-34-P - Page 88 of 736
TM 9-2815-225-34&P
0007 00
0007 00-10
BIG CAM I ENGINE REMOVAL (Contd)
36.
Remove two locknuts (10), lockwashers (9), U-bolt (5), shim (4), and cable mounting bracket (11)
from shift control cable (12). Discard locknuts (10) and lockwashers (9).
37.
Remove trunnion retaining pin (7) and trunnion (8) from transmission shift lever (6).
38.
Remove floor mat (2) from floor pan access cover (1).
39.
Remove ten screws (3), floor pan access cover (1), and shifter (13) from cab floor.
40.
Remove transmission temperature sending unit nut (35), washer (36), and electrical connector (37)
from transmission temperature sending unit (38).
41.
Remove twelve transmission bolts (30) securing transmission (26) to engine (18).
42.
Install two lifting brackets (17) on top of engine (18) with four bolts (16).
43.
Install lifting sling and lifting device on engine lifting brackets (17).
44.
Remove two rear engine mount nuts (29), washers (31) and bolts (14) from frame (32).
45.
Remove two front engine mount nuts (27), bolts (24) and washers (23) from crossmember (25).
WARNING
Use extreme care when handling heavy parts. Provide adequate
support and use assistance during procedure. Ensure that any
lifting device used is in good operating condition and of suitable load
capacity. Keep clear of heavy components supported only by lifting
device. Failure to do so may result in death or injury to personnel.
CAUTION
Raise engine slowly and carefully to prevent damage to splined
shaft. Failure to comply may result in damage to engine.
46.
Using lifting device and lifting sling, raise engine and remove two rear frame flat washers (34)
and rear vibration insulators (33) from rear engine mounting brackets (15).
Figure 11. Shifter Removal.
13
12
11
10
9
4
5
1
2
3
8
7
6
Back to Top
