TM-9-2815-225-34-P
ENGINE, DIESEL: 6 CYLINDER IN-LINE TURBOCHARGED, CUMMINS MODEL NTC-400
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST
JULY 2005
TM-9-2815-225-34-P - Page 94 of 736
TM 9-2815-225-34&P
0008 00
0008 00-4
BIG CAM III ENGINE REMOVAL (Contd)
CAUTION
Mark and tag all wires, hoses, etc., removed from vehicle for
proper reinstallation. Failure to comply may result in damage
to equipment.
4.
Disconnect four lighting harness electrical connectors (4).
5.
Remove four lighting harness screws (3), washers (2), and clamps (1) from lights and hood (5).
6.
Cut plastic tie (6) and remove lighting harness (7) from hood (5) and position aside. Discard
plastic tie (6).
WARNING
When removing hood tilt assist cables, hood must be supported.
Failure to do so may result in damage to equipment or injury
to personnel.
7.
Support hood (5) and open two chain link nuts (10). Remove tilt assist cables (8) from chain links
(9).
8.
Close hood (5) and remove two hood hinge locknuts (11) and bolts (12) from hood hinges (13).
Discard locknuts (11).
NOTE
Use three assistants or lifting strap and lifting device to
remove hood from vehicle.
9.
Remove hood (5) from vehicle.
Figure 4. Lighting Harness Removal.
3
4
2
3
2
1
2
3
3
2
7
6
1
4
5
1
1
Back to Top
