TM-9-2815-225-34-P
ENGINE, DIESEL: 6 CYLINDER IN-LINE TURBOCHARGED, CUMMINS MODEL NTC-400
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST
JULY 2005
TM-9-2815-225-34-P - Page 98 of 736
TM 9-2815-225-34&P
0008 00
0008 00-8
BIG CAM III ENGINE REMOVAL (Contd)
19.
Loosen exhaust S-pipe clamp (3) and remove from turbocharger outlet flange (4).
20.
Loosen two exhaust pipe nuts (6), screws (2), and exhaust S-pipe clamp (1). Remove exhaust
S-pipe (5) from exhaust pipe (7).
21.
Loosen heater hose clamp (9) and remove heater hose (8) and heater hose clamp (9) from heater
hose tube (10).
22.
Loosen heater hose clamp (12) and remove heater hose (13) and heater hose clamp (12) from
heater hose tube adapter (11).
23.
Loosen two vent hose clamps (16) and remove vent hoses (17) and vent hose clamps (16) from
radiator (15).
24.
Loosen bypass hose clamp (18) and remove bypass hose (19) from radiator (15).
25.
Loosen two lower radiator hose clamps (23) and remove lower radiator tube (28) and lower
radiator hose clamps (23) from radiator (15).
26.
Loosen three cooling outlet tube clamps (24) at water pump inlet (31) and cooling outlet tube (29).
27.
Remove cooling outlet tube nut (26) and screw (27) from support bracket (25).
28.
Remove cooling outlet tube (29) from water pump (30).
29.
Loosen two upper radiator hose clamps (20) and remove upper radiator hose (22) and upper
radiator hose clamps (20) from thermostat housing elbow (21) and radiator inlet tube (14).
Figure 10. Turbocharger Hose Removal.
1
2
3
4
5
6
7
Back to Top
