TM-9-2815-225-34-P

ENGINE, DIESEL: 6 CYLINDER IN-LINE TURBOCHARGED, CUMMINS MODEL NTC-400

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST

JULY 2005

TM-9-2815-225-34-P - Page 106 of 736

TM 9-2815-225-34&P

0008 00

0008 00-16

BIG CAM III ENGINE REMOVAL (Contd)

49.

Remove six cooling fan nuts (1), lockwashers (2), washers (3), and cooling fan (4) from cooling fan

clutch studs (5). Discard lockwashers (2).

50.

Position container under power steering reservoir (8), remove drain plug (9) and drain power

steering fluid. Install drain plug (9).

NOTE

Cap and plug all openings, hoses, and lines to prevent fluid

contamination.

51.

Loosen two power steering hose clamps (7) and remove power steering hoses (6) and clamps (7)

from power steering reservoir (8) and power steering pump (12).

52.

Remove power steering hose (11) from elbow (10) on power steering reservoir (8).

53.

Remove fuel return line (20) from fuel return line T-fitting (19) on engine (16).

54.

Remove fuel supply line (24) from fuel filter fitting (25).

55.

Remove retaining pin (15) and transmission modulator cable (23) from throttle lever (27).

56.

Remove two throttle position sensor cable clamp locknuts (26), screws (18), four washers (21),

clamp (17), and transmission modulator cable (23) from mounting bracket (22). Discard

locknuts (26).

57.

Remove two accelerator return springs (31), accelerator rod locknut (32), screw (30), and

accelerator rod (28) from lower throttle lever (29). Discard locknut (32).

58.

Remove tachometer cable (14) from fuel pump tachometer drive (13).

Figure 22. Cooling Fan Removal.

5

4

3

1

2