TM-9-2815-225-34-P
ENGINE, DIESEL: 6 CYLINDER IN-LINE TURBOCHARGED, CUMMINS MODEL NTC-400
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST
JULY 2005
TM-9-2815-225-34-P - Page 86 of 736
Figure 9. Accelerator Cable Disconnection.
TM 9-2815-225-34&P
0007 00
0007 00-8
BIG CAM I ENGINE REMOVAL (Contd)
26.
Remove return spring (5) from transmission modulator control bracket (6) and return spring
clip (4).
27.
Remove accelerator link nut (2), washer (3), spring clip (4), and accelerator link (15) from fuel
control lever pin (17).
28.
Remove retaining pin (13), washer (14), and transmission modulator control link (16) from fuel
control lever (18). Discard retaining pin (13).
29.
Remove two nuts (12), washers (11), shim (10), and U-bolt (9) from transmission modulator
control bracket (6).
30.
Remove two transmission modulator control bracket bolts (8), lockwashers (7), and transmission
modulator control bracket (6) from engine (1). Discard lockwashers (7).
31.
Remove ground strap bolt (33), starwasher (32), ground strap (34), and starter motor ground strap
(31) from engine (1). Discard star washer (32).
32.
Remove two starter motor terminal nuts (30), lockwashers (29), negative battery cable (28), and
positive battery cable (26) from starter motor (27). Discard lockwashers (29).
33.
Remove front hose clamp screw (35), nut (38), and hose clamp (36) from cooler hose bracket (37).
34.
Remove middle cooler hose bracket screw (25) and middle cooler hose bracket (23) from oil
pan (24).
35.
Remove rear cooler hose bracket screw (22), washer (21), and rear cooler hose bracket (20) from
transmission (19).
13
7
8
9
10
11
12
6
5
4
3
2
1
17
15
18
16
14
~
Back to Top
