TM-9-2920-242-35
STARTER, ENGINE ELECTRICAL, ASSEMBLY MODEL 1113943, 1113904 AND 1113944
TECHNICAL MANUAL; DIRECT SUPPORT, GENERAL SUPPORT AND DEPOT MAINTENANCE INCLUDING REPAIR PARTS
SEPTEMBER 1964
TM-9-2920-242-35 - Page 73 of 110
C 1, TM 9-2920-242-35
(5)
(6)
(7)
Install 0.516-inch ID nonmetallic washer
(H, step 3) and rubber bushing (G) on
terminal stud of brush holder assembly (J).
Install brush holder assembly (J) in com-
mutator end plate (A), and secure with
three No. 8 by ½-inch pan head screws
(M), lockwashers (L), and flat washers (K).
Install bushing (F, step 3), terminal stud
insulator (E), 0.520-inch ID flat washer
(D), ½-inch lockwasher (C), and ½-inch,
0.310-inch thick hex nut
(B).
56. Assembly of Drive Housing
Refer to figure 52 and assemble drive housing as
follows:
Figure 59. Drive housing position–model ENDT-673 engine
application.
a.
Install new sleeve bearing (C) in drive housing
(B). Drill oilhole and ream sleeve bearing bore to
limits specified in wear limits (para
41e).
b.
Saturate wick (H), and felt plug (D) with oil
(OE).
c.
Apply sealer to expansion plug seat. Install
felt plug (D), gasket (F), and expansion plug (E).
d.
Install wick (H) and fill reservoir with oil
(OE),
and install pipe plug (G).
e.
Install rubber plugs (A) in housing (B).
57. Assembly of Starter Assembly
Refer to paragraph 35 for assembly for starter
assembly except refer to figures 59 through 62 when
indexing the drive housing.
Figure 60. Pinion housing position—model LD-465-1 engine
application.
64
Back to Top
