TM-9-2920-257-30-P
GENERATOR, ALTERNATING CURRENT, 200 AMPERES
TECHNICAL MANUAL; DIRECT SUPPORT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS
MAY 1987
TM-9-2920-257-30-P - Page 31 of 111
TM 9-2920-257-30&P
CHAPTER 3
GENERATOR MAINTENANCE
Section I.
PN 2260AC AND A0012266AA
3-1.
CONSTRUCTION
The generator is a belt driven, air-cooled device used for producing the necessary direct current to charge the vehicle and
equipment batteries.
The generator consists of a drive housing, stator, rotor, anti-drive end housing, and cooling fan.
The
drive end housing contains positive and negative rectifiers, brushes, seals, and bearings.
3-2.
GENERAL INSTRUCTIONS
a.
The procedures discussed in this section cover complete disassembly of the generator.
b.
In cases where the generator does not require complete disassembly, disassemble only to the point required to
inspect, clean, and replace the damaged component.
3-3.
GENERATOR REPAIR INSTRUCTIONS
a.
Generator Cleaning Procedures.
(1.)
Clean exterior surfaces of generator as follows:
Change 1
3-1
Back to Top
