TM-9-2920-257-30-P
GENERATOR, ALTERNATING CURRENT, 200 AMPERES
TECHNICAL MANUAL; DIRECT SUPPORT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS
MAY 1987
TM-9-2920-257-30-P - Page 34 of 111
TM 9-2920-257-30&P
(2) Remove cover plate (fig. 3-1).
NOTE
Scribe cover plate and drive end housing assembly before
removing cover plate.
(a) Remove six screws (4) and eight screws (5) securing cover
plate (6) to drive end housing assembly (21).
(b) Remove cover plate (6).
(3) Remove connector assembly and mounting plate (fig. 3-2).
(a) Remove two brass bolts (1) securing two heavy black
connector leads and thin red lead to positive rectifier heat sink.
(b) Remove four screws (2) and lock washers (3) securing
connector assembly (4) and mounting plate (5) to drive end housing
assembly (6).
Move connector assembly and mounting plate to expose
printed circuit panel assembly (7).
(c) Remove three screws (8) and three lock washers (9)
securing three thin black connector leads and two thin black brush
leads to printed circuit panel assembly (7).
(d) Remove connector assembly (4) and mounting plate (5) from
drive end housing assembly (6).
Scribe mounting plate and drive end
housing assembly.
3- 4
Back to Top
