TM-9-2920-257-30-P
GENERATOR, ALTERNATING CURRENT, 200 AMPERES
TECHNICAL MANUAL; DIRECT SUPPORT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS
MAY 1987
TM-9-2920-257-30-P - Page 73 of 111
TM 9-2920-257-30&P
DIRECT SUPPORT MAINTENANCE
REPAIR PARTS AND SPECIAL TOOLS LIST
Section I .
Introduction
C-1.
Scope.
This appendix lists spares and repair parts; special tools;
special test, measurement,
and diagnostic equipment (TMDE); and other special
support equipment required for performance of direct support maintenance
o f
the 200 AMP engine generator.
It authorizes the requisitioning and issue of
spares and repair parts as indicated by the source and maintenance codes.
C-2.
General.
This Repair Parts and Special Tools List is divided into the
following sections:
a.
Section II .
Repair Parts Lists.
A list of spares and repair parts
authorized for use in the performance of maintenance.
The list also includes
parts which must be removed for replacement of the authorized parts.
Parts
lists are composed of functional groups in alpha sequence, with the parts in
each group listed in figure and item number sequence.
Bulk materials are
listed in NSN sequence.
b.
Section III .
Special Tools List.
See Chapter 1, Section II,
Special Tools and Equipment.
c.
Section IV.
National Stock Number and Part Number Index.
A list ,
in National item identification number (NIIN) sequence, of all National stock
numbers (NSN) appearing in the listings, followed by a list, in alphanumeric
sequence,
of all part numbers appearing in the listings.
National stock
numbers and part numbers are cross-referenced to each illustration figure and
item number appearance.
C- 1
APPENDIX C
Back to Top
