TM-9-2990-206-34P
TURBOSUPERCHARGER AlRESEARCH MODEL T18C01
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LISTS)
TM-9-2990-206-34P - Page 21 of 85
TM
9-2990-206-34&P
Section Il. GENERAL MAINTENANCE
2-3. GENERAL.
Special tools, repair parts, and equip-
ment over and above those available to
the using organization are supplied to
direct and general support units for
maintaining and repairing the material.
2-4. COMMON TOOLS AND EQUIPMENT.
For authorized common tools and equip-
ment refer to the Modified Table of
Organization and Equipment (MTOE)
applicable to your unit.
2-5.
SPECIAL TOOLS.
A thread tap and screw thread inserter
are required for repair of these turbo-
superchargers.
2-6. IMPROVISED TOOLS.
The holding fixture shown below
applies only to direct and general sup-
port units to enable these maintenance
organizations to fabricate it locally.
it is of chief value to units engaged
in repairing a large nunber of similar
components. However, it is not
essential for repair and is not avail-
able for issue.
NOTE
Fabricate from hard wood or
aluminum. Drill eleven 0.375 inch
(9.5 mm) holes equally spaced on
the 5.25 inch (133.4 mm) diameter.
Cut out 5.00 inch (127 mm) circle.
Bottom block is solid. Assemble
top and bottom blocks with screws
or bolts.
2-7.
REPAIR PARTS.
Repair parts are listed and illustrated
in Appendix B of this manual.
TA0780 7
2-5/2-6 (blank)
Back to Top
