TM-9-3990-260-14-P

CONTAINER ROLL-IN/OUT PLATFORM (CROP) MODEL M3 AND MODEL M3A1

TECHNICAL MANUAL; OPERATOR’S, UNIT, DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)

JULY 2001

TM-9-3990-260-14-P - Page 178 of 306

TM 9-3990-260-14&P

8-2.

TROUBLESHOOTING SYMPTOMS (CONT).

Table 8-2. Operator Troubleshooting Procedures

MALFUNCTION

TEST OR INSPECTIONS

CORRECTIVE ACTION

1.

CONTAINER TRANSPORT LOCKS WON’T ENGAGE SHORING SLOTS IN ISO SHIPPING

CONTAINER.

Are shim plates out of position?

•

Remove locking pin and adjust position of shim plates in front of or behind latch.

Replace locking pin. (See paragraph 7-16 or 7-17).

Is locking pin missing or damaged?

•

If locking pin is missing or damaged, contact unit maintenance.

Section II. MAINTENANCE INSTRUCTIONS

8-3.

MAINTENANCE INTRODUCTION.

Maintenance procedures for the replacement or repair of the A-frame, twistlocks, rollers, container transport locks,

wear plates, load restraint plates, door holders, bumpers and stowage box doors are covered in Chapter 9.

8-2