GROUNDPoor. Tight and clean
grounds must be made between the
set and the equipment mounting
sheLf± ²ikewise, run a ground strap
from the ³´µ binding post ¶o the
rack· shel¸er waLl or other convenient
spot. Watch the ground connection.
Some straps get attached ¶o the
´ECEIVE´ I¹ binding post by
mistake. That's no ground at aLLº
H»A¼ »X½HANG»R-µirty. Make
sure air gets through the radio set.
¾ithou¶ it, overheating wilL ¿amage
the set. Keep cLothes and o¶her gear À
from plugging the vents. If they' re ;
cLogged wi¶h dust· shut the set down
AN¼»NNÁ¹o connection made.
Transmitting without either the whip
or ¹/³´ÂÃ50 connected can refLec¶
power to the receiverÃtransmitter and
knock out the set. Äatch for a tooÅ
Long CxÃ10171 cabLe, too. That eÆÇ
tra Length becomes par¶ of the antenÈ
na and cÉn make tuning and loading
between 23Ã26 MÊz impossibLe. Cut
the cable to the leng¶h you need for
your installation.
and cLean ¶he eÆchanger. Make sure
irR-±"²
³:
the amp's bLower motor is working,
too±
·
¼UNËNÌÃÍperators not observing ¶ime limits. Time is a ¶op priority when
tuning the Î106Ï F'rinstancз Let i¶ warm up 10 minutes in ÍVE¹ ͹ before
you start± Ínce the ÊV ´ESET switch goes to TѹE, you have 2 minutes
to tune and LoaÒ. If you can't make itÓand never fudge-switch back ¶o
ÍÔE´ÂTE (and put SE´VICE SE²ECTÍ´ to ST¹µ BY) for 5 minutes before
trying again. FinalLy· turn the ´T to ST¹µ BY for 2 minutes before shutÈ
ting the set down. The raÕio is covered in TM 11Ã5820Ã520Ã10Ï
PP-7286 Cables
Dear Macon,
We were issued a PP-7286 bat±
tery charger for our ²²-557
nickel-cadmium batteries.
Our problem is the -557's won't
fit in the charger's battery
holders³ Para 2-7f
of
TM
11-6130-392-12 says we need
remote cables to charge other
batteries. But the pub doesn't
have the NSN's³
Can you help?
SSG T³M³²³
Dear Sergeant
T M.
B.,
Sure can± Sergeant.
AV´µ
YE LANDW8±eRS
t
IFy²r Bat³´iµs dOn'¶
f´,
·¸ b¹º G»¼ ½¾¿ÀÁlV Ã
CÄÅÆ ÇÈÉmÊËÌ-o ÍÎÏ
ÐÑKÒ ÓÔ wÕÖ× ØHÙ
INK!
Oly the BB-516baTeRfts in the PP²786's hoLers³
ÚÛ
´theµs take a rem´te
setup¶
·ere are 4 assembliEs¸ Cable assembly ¹º13145± NSN 599 5-01-08»3222¼
is the ´½e y´u need¸ It h´´ks up the BB-55¾± -505± ¿5ÀÁ an Ã590Ä
Å´ charGe BB-69Æ and -Á04 batteries± Get caÇle assEmbly± ÈSN
1420É01-0Áʺ1020.
Yu use a Ë-1314Á cabÌe assemblͱ NSÎ 6140ºÀ1ºÏ4-5461± t´ charGe
BBº588Ð ¿542 and -Ñ86 batÒeries¸
·e M-101Ó4 baÒtÔÕ tray assemÖl× Has cables For cØarging a BB-503 or
Ü541Ý
It's NSN 61ÙÚ01-Ï2-6Á5Û¸
·e Ü´mmuniÝati´Þs²ßlectà´nics á´mmanâ is moviãg äut to Get theså æçs
in tèe
Þß2
pub.
45