PS Magazine - TB 43-PS-438
PS, The Preventative Maintenance Monthly
ISSUE 438
MAY 1989
-
Clean all pars aNd the padlock
body with SolveNt. Then lubRicate
wi±h molybdenUm dIsuLfide powdeR.
\
Reassembling the Lock
²lide the cylindeR-with the key
opening (LaRge flat end) PointinG
down into the plUg. ³ush the
locking pins into the pLug unti´
the detent ball poPs out and
holds the cYlindeR in Place.
HErE'S ±Ow TO puT ²³E ´OCK TOGE²±Er
®
AGAIN:
4
±
²
±±
²
±
±±±
±±±±
.³´µ¶
.
--µµµµµµ
¶·¸;¹º»¼½
µµ¾µ¿ÀÁÁÂ.Ã
_
_ÄÅÆÇ
²et the plug on a flat suµace
with tHe slot towaRd you. ²liP the
cylindeR shIeld-with Its s´ot
away FRom you-into the plug.
The tumbleR shiEld goes in the p´ug
fla± side down and the cu¶ed edGe
poin±ing towaRd you.
±
56
²eat the RetaInIng Ring against the
tuMbleR sHIeld and ±he cy´inde·
sHield. ¸f it's not seated Right,
you can¹t seat the cylIndeRº
¸nstall tHe locking pIns»
shor pin fiRst.
MAY 89
¼i´tthe p´ug towaRd you and install the
detent bal´ by pushing it into the PluG
housing with the scRewdRiveR tiP.
MAy 89
57
³icK up the P´ug. ½nse¾ the contRol
Key, add the paw´, and tuRn ¿hÀ key
counteRclockwise to ÁÂÃOCÄÅ
Æold the lock housiÇg with the
´abe´ side down as you slide the
Plug assembly into the case. Tilt
the locK so that the shackle closes.
²
½f the shackle is open, the PaW´
kee s the lu fRom seatin .
•
Back to Top Back to Top
