MWO-5-2350-262-35-4

ARMORED COMBAT EARTHMOVER (ACE), M9

MODIFICATION WORK ORDER

MWO-5-2350-262-35-4 - Page 100 of 207

MWO 5--2350--262--35--4

3--71

SECTION VI INSTALLATION OF BUMP STOP CYLINDERS PRESSURE

TRANSDUCERS T8 AND T9 -- CONTINUED

3--14 INSTALLATION OF LEFT SIDE BUMP STOP CYLINDER PRESSURE TRANSDUCER

T9

NOTE

Steps a through e below apply to Figure 3--47.

a.

Remove and retain four screws from left actuator access plate in ejector bowl and remove actuator

access plate from frame per TM 5--2350--262--20--1, Actuator Access Plates Replacement.

b.

Remove circuit 9 hose (larger diameter hose, --6 hose) (1) from bulkhead fitting on aft side of plate. Do

not remove circuit 11 hose.

c.

Install diagnostic tee adapter, 6--4XHX6G5TP, (2) on circuit --9 fitting on aft side of bulkhead plate.

d.

Install pressure transducer, 12496923, (4) and o--ring, MS28778--4, (3) on far side connection on

diagnostic tee adapter (2) with transducer positioned as shown. This pressure transducer has been

functionally designated as T9.

e.

Reconnect circuit 9 hose from right forward manifold to in--line (straight) side of diagnostic tee adapter (2)

on aft side of bulkhead plate.

Figure 3--47. Installation of Left Side Bump Stop Cylinder Pressure Transducer T9