MWO-5-2350-262-35-4

ARMORED COMBAT EARTHMOVER (ACE), M9

MODIFICATION WORK ORDER

MWO-5-2350-262-35-4 - Page 101 of 207

MWO 5--2350--262--35--4

3--72

SECTION VII INSTALLATION OF FORWARD ACTUATORS PRESSURE

TRANSDUCERS T5 AND T6

3--15 INSTALLATION OF FORWARD RIGHT ACTUATOR #1 PRESSURE

TRANSDUCER T5

NOTE

Steps a and f below apply to Figure 3--48.

NOTE

Area where pressure transducer T5 will be installed can be accessed from bowl area and

from underneath vehicle. It is recommended that installation be accomplished from most

convenient position.

a.

Access port 3 (6) of forward right rotary actuator #1 (1).

b.

Tag and disconnect hydraulic hose (4) connected to port 3 (6) of forward right rotary actuator #1 (1). The

other end of this hydraulic hose connects to Port 3R of right forward manifold.

c.

Attach diagnostic tee adapter, 8--4XHX6G5TP, (5) to port 3 of forward right rotary actuator #1.

d.

Attach pressure transducer, 12496923, (2) and o--ring, MS28778--4, (3) to 90--degree port of diagnostic

tee adapter (5). This pressure transducer has been functionally designated as T5.

e.

Connect hydraulic hose removed in step b above to in--line port of diagnostic tee adapter (5) attached to

port 3 of forward right rotary actuator #1.

f.

Reinstall actuator right access plate in ejector bowl using four saved machine bolts per

TM 5--2350--262--20--1, Actuator Access Plates Replacement, or leave off for installation of electrical

wiring harness in Chapter 5.

Figure 3--48. Installation of Pressure Transducer T5