SMI-9-2320-387-14P-1
TRUCK, UTILITY: EXPANDED CAPACITY
SUPPLEMENTAL OPERATION, MAINTENANCE, AND REPAIR PARTS INSTRUCTIONS
JULY 2004
SMI-9-2320-387-14P-1 - Page 346 of 671
12-124. TROOP/CARGO WINTERIZATION TOP COVER ASSEMBLY REPLACEMENT
(Cont’d)
SMI 9-2320-387-14&P-1
12-198
Change 4
NOTE
When installing top cover assembly, ensure fastener straps are
installed on inside of enclosure.
10.
Center and install top cover assembly (6) over top enclosure assembly (7), rear end closure
assemblies (13), and vehicle body (12).
11.
Attach top cover assembly fastener strip (20) to cab top cover strip (19).
12.
Install eight fastener straps (37) on bow assemblies (38).
NOTE
Top cover assembly is oversized to allow for shrinkage for proper fit.
13.
Install top cover assembly (6) and two clamping strips (3) on two rubber strips (8), channel (5), and
rear end closure assemblies (13) with fourteen screws (4).
14.
Install top cover assembly (6) and two clamping strips (2) on two seals (10), outside corner
plates (9), and rear end closure assemblies (13) with six screws (1).
15.
Install top cover assembly (6) and two clamping strips (14) on two rubber strips (11) and rear end
closure assemblies (13) with sixteen screws (15).
16.
Install top cover assembly (6) and clamping strip (28) on rubber strip (34) and right rear vehicle
body (31) with eight capscrews (29) and nuts (33).
17.
Secure top cover assembly (6) and clamping strip (28) to rubber strip (34) and right end closure (32)
with screw (30).
18.
Install top cover assembly (6) and plate assembly (26) on rubber strip (34), fuel tank filler (27), and
right rear vehicle body (31) with three screws (25) and spring nuts (16) (if removed).
19.
Install top cover assembly (6) and clamping strip (22) on rubber strip (34) and right rear fixed
door (23) with six capscrews (24) and nuts (17).
20.
Secure top cover assembly (6) and clamping strip (22) to rubber strip (34) and right rear fixed
door (23) with capscrew (21) and nut (18).
21.
Install top cover assembly (6) and clamping strip (44) on rubber strip (46) and left rear vehicle
body (41) with ten capscrews (43) and nuts (39).
22.
Install top cover assembly (6) and clamping strip (44) on rubber strip (46) and left end closure (40)
with screw (42).
23.
Install top cover assembly (6) and clamping strip (49) on rubber strip (46) and left rear fixed
door (45) with six capscrews (48) and nuts (47).
24.
Secure top cover assembly (6) and clamping strip (49) to rubber strip (46) and left rear fixed
door (45) with capscrew (35) and nut (36).
Back to Top
