TB 9-2300-378-14
(2) Installation
(a)
Put dust detector warning light box assembly in position on bracket and
secure box assembly to bracket with two screws, lockwashers, and nuts.
Make sure screws are installed from bottom (view B).
(b)
Put spacer in position on switch bracket on gage indicator panel.
(c)
Put dust detector warning light box assembly and bracket on top of spacer,
secure bracket and spacer
to switch bracket with four screws an d
lockwashers.
CAUTION
Do not overtighten harness connector (view A) damage to
connector may result.
(d)
Tighten harness connector on dust detector
A).
warning light box assembly (view
Figure 6-23. Dust detector warning light wiring harness assembly replacement
(Sheet 1 of 2).
6-59