TB-9-2320-279-13-P-2

TECHNICAL BULLETIN; CREW PROTECTION KIT

OPERATOR’S, UNIT AND DIRECT SUPPORT MAINTENANCE MANUAL, INSTALLATION INSTRUCTIONS, AND REPAIR PARTS AND SPECIAL TOOLS LISTS (RPSTL)

SEPTEMBER 2005

TB-9-2320-279-13-P-2 - Page 176 of 460

Change 1

0031 01-6

TB 9-2320-279-13&P-2

SIDE ARMOR REPLACEMENT - MODEL B - CONTINUED

0031 01

REMOVAL - CONTINUED

13.

If necessary, remove seal (38) from side of cab.

CLEANING AND INSPECTION

Clean and inspect all parts IAW

General Maintenance Instructions

(WP 0011 00).

INSTALLATION

1.

If removed, install seal (38) by removing backing and apply to side of cab.

2.

Install support bracket (17), nine washers (20), and bolts (21) on side of vehicle.

WARNING

Use extreme caution when handling heavy parts. Provide adequate support and use assistance during proce-

dure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of

heavy parts supported only by lifting device. Failure to follow this warning may cause injury or death to per-

sonnel.

CAUTION

Do not lift side armor with lifting eye on door. Use two lifting eyes located on side armor.

NOTE

Side armor weighs 360 lb (163 kg) without door installed.

440-061

38