TB-9-2320-279-13-P-2
TECHNICAL BULLETIN; CREW PROTECTION KIT
OPERATOR’S, UNIT AND DIRECT SUPPORT MAINTENANCE MANUAL, INSTALLATION INSTRUCTIONS, AND REPAIR PARTS AND SPECIAL TOOLS LISTS (RPSTL)
SEPTEMBER 2005
TB-9-2320-279-13-P-2 - Page 65 of 460
TB 9-2320-279-13&P-2
0012 00-1
DOOR HANDLE ASSEMBLY REPLACEMENT
0012 00
THIS WORK PACKAGE COVERS
Removal, Cleaning and Inspection, Installation
INITIAL SETUP
Maintenance Level
Unit
Tools and Special Tools
Tool Kit, General Mechanic’s (Item 13, WP 0034
00)
Materials/Parts
Rag, Wiping (Item 7, WP 0035 00)
Locknut
References
WP 0011 00
Equipment Conditions
Vehicle parked on level ground (TM 9-2320-279-
10)
Parking/Emergency Brake applied (TM 9-2320-
279-10)
Engine off (TM 9-2320-279-10)
If equipped, Battery Disconnect Switch in OFF
position (TM 9-2320-279-10)
NOTE
The following procedure is for left door assembly. Right door assembly is identical.
REMOVAL
1.
Open door assembly.
2.
Remove locknut (9) and washer (10) from door cam (7) and position link rod (11) aside. Discard locknut.
3.
Loosen setscrew (4) and remove interior grab handle (6), door cam (7), and bolt (8).
4.
Remove four capscrews (2), washers (3), interior handle spacer (5), and exterior door handle (1).
417-030
1
2,3
4
5
9,10
11
8
7
6
Back to Top
