TB-9-2320-280-35-12
TECHNICAL BULLETIN
INSTALLATION INSTRUCTIONS FOR EPLRS NETWORK MANAGER VEHICLE WITH AMTECH TOP
OCTOBER 2006
CHANGE 1
TB-9-2320-280-35-12 - Page 47 of 162
TB 9-2320-280-35-12
5-19
10-4.
Locate, mark, and drill two 0.156-in. diameter holes (9) in windshield center post (12).
10-5.
Secure speaker cables (3) and (5) to windshield center post (12) with upper right bolt (6) from wiper
motor and clamp (7).
NOTE
Before tightening three cable clamps pull excess cable below
bottom cable clamp on windshield center post.
10-6.
Install two cable clamps (10) on windshield center post (12) with two self-tapping screws (11).
10-7.
Install twelve tie straps (8), evenly spaced along speaker cables, between loudspeakers and top cable
clamp on windshield center post.
10-8.
Install three cable straps (8) to speaker cables (3) and (5) along windshield center post (12).
10-9.
Connect speaker cables (3) and (5) to mounting base (13).
Figure 5-24.
5
6
7
10
8
9
10
11
12
9
11
3
8
~
13
~
8.0
4.0
7. LOOP CLAMP – MS21333-96 – QTY. 1
8. TIE STRAP – MS3367-1-0 – QTY. 15
10. LOOP CLAMP – MS21333-65 – QTY. 2
11. SELF-TAPPING SCREW – 9421073 – QTY. 2
Back to Top
