TB-9-2320-280-35-15
TECHNICAL BULLETIN
INSTALLATION INSTRUCTIONS FOR RETRANSMISSION VEHICLE WITH AMTECH TOP FOR AN/VRC-92F, AN/UYK-128 (V)4, RT-1812, AN/VSQ-2 (V), AB-1386/U, DAGR, AN/PSN-11
SEPTEMBER 2006
TB-9-2320-280-35-15 - Page 25 of 168
TB 9-2320-280-35-15
5-1
Figure 5-1.
3. CAB ENCLOSURE PANEL – 12447141 – QTY. 1
4. INSERT – 12446871-2 – QTY. 2
1
2
3
4
~
A
A
B
B
B
CHAPTER 5
INSTALLATION PROCEDURES
Section I. SCOPE
This chapter provides instructions for installation of C4ISR items in the vehicle. When installing C4ISR
equipment, be sure to read and follow instructions and illustrations carefully.
Section II. INSTALLATION OF TERMINAL BOARDS
Use the following procedure to install additional terminal boards to provide adequate power connections.
Section III. PANEL MODIFICATIONS
NOTE
• For vehicles without cab enclosure panel, begin with step 3-1 and
use cab enclosure panel NSN 2510-01-413-5993.
• For vehicles with cab enclosure panel, begin with step 3-3.
• All dimensions are in inches.
3-1.
Place cab enclosure panel (3) in position. Locate, mark, and drill five 0.159-in. diameter holes
marked A and B in B-beam (1) and battery box (2).
3-2.
Enlarge two lower mounting holes marked A to 0.390-in. diameter, and install two inserts (4) in
battery box (2).
Back to Top
