TB-9-2320-280-35-15
TECHNICAL BULLETIN
INSTALLATION INSTRUCTIONS FOR RETRANSMISSION VEHICLE WITH AMTECH TOP FOR AN/VRC-92F, AN/UYK-128 (V)4, RT-1812, AN/VSQ-2 (V), AB-1386/U, DAGR, AN/PSN-11
SEPTEMBER 2006
TB-9-2320-280-35-15 - Page 30 of 168
TB 9-2320-280-35-15
5-6
Figure 5-7.
Figure 5-8.
3 X 24V FUSES, 25 AMP
POSITIVE FUSE WIRES
24V BUSS BAR
GROUND WIRE
VEHICLE
BATTERY
12V FUSE, 15 AMP
12V BUSS BAR
GROUND STRAP
POWER WIRE
EXISTING VEHICLE POWER STUD
EXISTING VEHICLE BUSS BAR
EXISTING VEHICLE SHUNT
GROUND SCREW
VEHICLE BATTERY
2. TERMINAL LINK – MS25226-6N-2 – QTY. 1
3. FUSE WIRE ASSEMBLY (12V) – 12480568-2 – QTY. 1
4. LOCKNUT – 271175 – QTY. 2
7. GROMMET – 2400 – QTY. 1
Section VII. FINAL ASSEMBLY, TERMINAL BOARD WIRING, AND TERMINAL LINK
NOTE
Perform steps 7-1 and 7-2 if hole does not exist in battery box.
7-1.
Locate, mark, and drill one 2.00-in. diameter hole (6) in upper right corner of rear wall of battery
box (9).
7-2.
Install rubber grommet (7) in hole (6).
7-3.
Secure terminal link (2) and fuse wire (3) to 12V terminal board (1) with two locknuts (4), and
install terminal board cover (5).
7-4.
Route 11.00-in. wire (8) through battery box hole (6).
1
2
3
5
4
6
7
8
9
Back to Top
