TB-9-2320-280-35-15
TECHNICAL BULLETIN
INSTALLATION INSTRUCTIONS FOR RETRANSMISSION VEHICLE WITH AMTECH TOP FOR AN/VRC-92F, AN/UYK-128 (V)4, RT-1812, AN/VSQ-2 (V), AB-1386/U, DAGR, AN/PSN-11
SEPTEMBER 2006
TB-9-2320-280-35-15 - Page 34 of 168
TB 9-2320-280-35-15
5-10
7-16.
Secure three 24V fuse wire assemblies (25) and one 12V fuse wire assembly (3) to B-beam (22) with
four self-tapping screws (36).
NOTE
For models equipped with power stud, perform step 7-17.
Otherwise, proceed to step 7-18.
7-17.
Secure 24V terminal board power wire terminal lug (28) to power stud (40) with lockwasher (38)
and existing nut (39).
7-18.
Secure 24V terminal board power wire terminal lug (28) to terminal board (37) with lockwasher (38)
and existing nut (39).
7-19.
Install decal (35) on B-beam (22).
7-20.
If previously removed, install right-hand rear fixed door. (Refer to TM 9-2320-280-20.)
7-21.
Install batteries. (Refer to TM 9-2320-280-20.)
Figure 5-13.
35
22
36
28
37
38
39
3
28
40
38
39
35. DECAL – 12339060 – QTY. 1
36. SELF-TAPPING SCREW – 12342499-2 – QTY. 4
38. LOCKWASHER – MS35338-48 – QTY. 1
25
~
Back to Top
