TB-9-2320-280-35-15
TECHNICAL BULLETIN
INSTALLATION INSTRUCTIONS FOR RETRANSMISSION VEHICLE WITH AMTECH TOP FOR AN/VRC-92F, AN/UYK-128 (V)4, RT-1812, AN/VSQ-2 (V), AB-1386/U, DAGR, AN/PSN-11
SEPTEMBER 2006
TB-9-2320-280-35-15 - Page 37 of 168
TB 9-2320-280-35-15
5-13
Section IX. INSTALLATION OF SINCGARS MOUNTING TRAY AND AMP GUARD
9-1.
Remove paint from vicinity of four mounting holes (6) on integrated rack (7) and vicinity of four
mounting holes (5) on bottom of mounting base (4).
9-2.
Apply anti-seize compound to vicinity of four mounting holes (6) on integrated rack and four
mounting holes (5) on bottom of mounting base (4) as required.
NOTE
Two lockwashers and one nut are used on driver-side screws only.
9-3.
Install mounting base (4) and amp guard (9) on integrated rack (7) with two capscrews (2), four
lockwashers (1), and two nuts (8). Secure MT-6352/VRC mounting base (4) on integrated rack (7)
with two capscrews (3) and two lockwashers (1).
9-4.
Place warning decal (10) on amp guard (9).
Figure 5-18.
1. LOCKWASHER – MS45904-72 – QTY. 6
2. CAPSCREW – B1821BH031F125N – QTY. 2
3. CAPSCREW – B1821BH031F100N – QTY. 2
4. MOUNTING BASE, MT-6352/VRC – A3013367-1 – QTY. 1
8. NUT – MS51968-5 – QTY. 2
9. AMP GUARD – 872842-1 – QTY. 1
10. DECAL – 861868-2 – QTY. 1
6
5
1
9
10
2
1
3
4
7
1
8
9
5
5
5
6
Back to Top
