TB-9-2320-280-35-15
TECHNICAL BULLETIN
INSTALLATION INSTRUCTIONS FOR RETRANSMISSION VEHICLE WITH AMTECH TOP FOR AN/VRC-92F, AN/UYK-128 (V)4, RT-1812, AN/VSQ-2 (V), AB-1386/U, DAGR, AN/PSN-11
SEPTEMBER 2006
TB-9-2320-280-35-15 - Page 31 of 168
TB 9-2320-280-35-15
5-7
7-5.
Connect wire (8) to existing positive 12V battery terminal end (11) with existing screw (10) and
nut (12).
7-6.
Position cab enclosure panel (13) in rear floor pan (21) and rear of B-beam (22). Do not secure cab
enclosure panel (13) at this time.
7-7.
Route ground cable (17) through battery box hole (6).
7-8.
Secure terminal lug (15) to center terminal of terminal board (14) with nut (16), and secure
terminal lug (20) to shunt (19) with existing screw (18).
7-9.
Install four additional nuts (16) on terminal board (14).
Figure 5-9.
Figure 5-10.
13
10
11
12
8
14
17
15
18
6
19
20
22
21
16
~
~
16. PLAIN-ASSEMBLED NUT – 271169 – QTY. 5
17. GROUND CABLE ASSEMBLY – 12480567-1 – QTY. 1
Back to Top
