TB-9-2320-302-13-P-2

CREW PROTECTION KIT PART 2 OF 3

TECHNICAL BULLETIN; OPERATOR'S, UNIT AND DIRECT SUPPORT, MAINTENANCE MANUAL, INSTALLATION INSTRUCTIONS AND REPAIR PARTS AND SPECIAL TOOLS LIST

JUNE 2007

TB-9-2320-302-13-P-2 - Page 128 of 396

TB 9-2320-302-13&P-2

RIGHT B-PILLAR ARMOR REPLACEMENT - CONTINUED

0023 00

0023 00-2

REMOVAL

1.

Remove four nuts (1), washers (2), two saddle clamps (4), and exhaust stack (3).

WARNING

Use extreme caution when handling heavy parts. Provide adequate support and use assistance during proce-

dure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of

heavy parts supported only by lifting device. Failure to follow this warning may cause injury or death to per-

sonnel.

2.

Using a lifting device, support muffler (5) and loosen

two bolts (7) on seal clamp (6).

3.

Using a lifting device, remove four nuts (9), washers

(10), two saddle clamps (8), muffler (5), and seal

clamp (6).

4.

Discard seal clamp (6). Remove lifting device from

muffler.

5.

Remove four nuts (11), lockwashers (12), washers

(13), and rear cab grab handle with adapter plates (14)

from rear cab armor frame. Discard lockwashers.

440-028

3

4

1,2

5

6

7

8

9,10

11,12,13

14