TB-9-2320-302-13-P-2
CREW PROTECTION KIT PART 2 OF 3
TECHNICAL BULLETIN; OPERATOR'S, UNIT AND DIRECT SUPPORT, MAINTENANCE MANUAL, INSTALLATION INSTRUCTIONS AND REPAIR PARTS AND SPECIAL TOOLS LIST
JUNE 2007
TB-9-2320-302-13-P-2 - Page 137 of 396
TB 9-2320-302-13&P-2
A-PILLAR ARMOR REPLACEMENT - CONTINUED
0024 00
0024 00-3/(0024 00-4 Blank)
INSTALLATION
WARNING
•
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during proce-
dure. Failure to follow this warning may cause injury to personnel.
•
For proper threat protection, armor must be installed correctly into the armor frame. During installation,
ensure that the surface marked “STRIKE FACE” is facing outward towards the threat. Exposing the passive
side of the ballistic panel outward makes the armor less effective. Failure to follow this warning may cause
injury or death to personnel.
1.
With assistance, install A-pillar armor (4), three washers (3), new lockwashers (2), and bolts (1) on vehicle.
2.
Install two washers (7), bolts (8), washers (6), and new locknuts (5) on A-pillar armor (4).
END OF WORK PACKAGE
Back to Top
