TB-9-2320-302-13-P-2
CREW PROTECTION KIT PART 2 OF 3
TECHNICAL BULLETIN; OPERATOR'S, UNIT AND DIRECT SUPPORT, MAINTENANCE MANUAL, INSTALLATION INSTRUCTIONS AND REPAIR PARTS AND SPECIAL TOOLS LIST
JUNE 2007
TB-9-2320-302-13-P-2 - Page 140 of 396
TB 9-2320-302-13&P-2
LEFT WHEEL WELL BLAST DEFLECTOR REPLACEMENT - CONTINUED
0025 00
0025 00-2
REMOVAL
1.
If equipped, remove nut (2), lockwasher (3), washer
(4), and washer bottle fill tube (1) from stud plate (5).
Discard lockwasher.
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during proce-
dure. Failure to follow this warning may cause injury or death to personnel.
NOTE
Note orientation of bolts on wheel well blast protection extension panel to aid installation.
2.
With assistance, remove seven locknuts (23), washers (24), bolts (26), washers (25), washer plate (27), and wheel well
blast deflector extension (19) from forward mounting plate (18). Discard locknuts.
3.
Remove two locknuts (13), washers (14), bolts (16), washers (15), bracket (17), and hood latch (12) from bracket (11).
Discard locknuts.
4.
Remove four locknuts (7), washers (8), bolts (10), washers (9), and bracket (11) from left firewall armor. Discard lock-
nuts.
5.
Remove two bolts (29), washers (31), lockwashers (30), nut plate (32), drive shaft plate (6), stud plate (5), and bracket
(28) from left firewall armor. Discard lockwashers.
6.
Remove two bolts (20), washers (22), lockwashers (21), and forward mounting plate (18) from left firewall armor. Dis-
card lockwashers.
440-032
1
2,3,4
5
Back to Top
