TB-9-2320-302-13-P-2

CREW PROTECTION KIT PART 2 OF 3

TECHNICAL BULLETIN; OPERATOR'S, UNIT AND DIRECT SUPPORT, MAINTENANCE MANUAL, INSTALLATION INSTRUCTIONS AND REPAIR PARTS AND SPECIAL TOOLS LIST

JUNE 2007

TB-9-2320-302-13-P-2 - Page 133 of 396

TB 9-2320-302-13&P-2

RIGHT B-PILLAR ARMOR REPLACEMENT - CONTINUED

0023 00

0023 00-7/(0023 00-8 Blank)

INSTALLATION - CONTINUED

10.

Install rear cab grab handle with adapter plates (14),

four washers (13), new lockwashers (12), and nuts

(11) on rear cab armor frame.

WARNING

Use extreme caution when handling heavy parts. Provide adequate support and use assistance during proce-

dure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of

heavy parts supported only by lifting device. Failure to follow this warning may cause injury or death to per-

sonnel.

11.

Using a lifting device, support muffler (5) and install new seal clamp (6), muffler (5), two saddle clamps (8), four wash-

ers (10), and nuts (9).

12.

Tighten two bolts (7) on seal clamp (6).

13.

Install exhaust stack (3), two saddle clamps (4), four washers (2), and nuts (1). Remove lifting device from muffler.

END OF WORK PACKAGE

440-028

3

4

1,2

5

6

7

8

9,10

11,12,13

14