TB-9-2320-302-13-P-2

CREW PROTECTION KIT PART 2 OF 3

TECHNICAL BULLETIN; OPERATOR'S, UNIT AND DIRECT SUPPORT, MAINTENANCE MANUAL, INSTALLATION INSTRUCTIONS AND REPAIR PARTS AND SPECIAL TOOLS LIST

JUNE 2007

TB-9-2320-302-13-P-2 - Page 233 of 396

ArmorWorks

W

ORK

L

IGHT

C

ONNECTOR

NOTE: Re-install the screws on the connectors and save the connectors for later re-installation.

REQUIRED TOOLS:

5/32” Drill Bit and Drill

Small Slotted (Flat-Tip) Screwdriver

Remove the work light connector from

the b-pillar on both sides of the cab.

1.) Drill out the two rivets securing

each connector.

2.) Pull the connectors out from the

b-pillars and disconnect the wires

using the small screwdriver.

3.) Leave the wires hanging approximately

6” out of the b-pillars as they will be

reconnected later.

TB 9-2320-302-13&P-2

0038 00-21