TB-9-2320-302-13-P-2

CREW PROTECTION KIT PART 2 OF 3

TECHNICAL BULLETIN; OPERATOR'S, UNIT AND DIRECT SUPPORT, MAINTENANCE MANUAL, INSTALLATION INSTRUCTIONS AND REPAIR PARTS AND SPECIAL TOOLS LIST

JUNE 2007

TB-9-2320-302-13-P-2 - Page 242 of 396

ArmorWorks

4.) Insert a 4X 4 block as shown

.

*

NOTE:

If your vehicle has a shifter cable

remove from shifter side and feed

through opening in center panel.

PREPARATION:

1.) For installation it is necessary to jack up the rear of the cab or

utilize a crane if available.

2.) Remove the nuts from the rear vibration mounts.

3.) Unsnap cables under driver and passenger sides. Remove canon plug on drivers side.

INSTALLATION:

1.) Place templates over floor mats and

drill holes accordingly.

2.) Use hole saw to drill a 1-1/8” hole into

the seat mounting pedestal

3.) Insert mine blast mounting bracket in

the back drill holes on underbody

4.) Feed electrical cord through armor

5.) Insert stud plates through armor

TB 9-2320-302-13&P-2

0038 00-30