TB-9-2320-302-13-P-2

CREW PROTECTION KIT PART 2 OF 3

TECHNICAL BULLETIN; OPERATOR'S, UNIT AND DIRECT SUPPORT, MAINTENANCE MANUAL, INSTALLATION INSTRUCTIONS AND REPAIR PARTS AND SPECIAL TOOLS LIST

JUNE 2007

TB-9-2320-302-13-P-2 - Page 251 of 396

ArmorWorks

1.) Thread the provided eyebolts into the

top angle rail of the Driver Side B-Pillar

Armor Frame.

These eyebolts can be

used to attach a lifting strap from the ar-

mor frame to a forklift or overhead crane.

Option Two:

2-man lift

1.) Rather than using a forklift use a two

man lift to hoist B-Pillar.

2.) Hoist the armor into position, guiding

the four 3/8” threaded studs into their

mating slots in the Rear Cab Armor

Frame.

Secure the studs with the pro-

vided 3/8” flat washers, lock washers,

and hex nuts.

NOTE: The hex nuts should only be

finger-tight at this time.

3.) Align the slotted tabs on the top and

bottom of the forward side of the armor

frame with the mating slotted tabs on the

Door Support Frame.

Use the provided

3/8” bolts, flat washers, and metal lock-

nuts to secure the tabs.

NOTE:

Do not fully tighten the lock

nuts at this time.

Option One:

Forklift

2.) Hoist the armor into position, guiding

the four 3/8” threaded studs into their

mating slots in the Rear Cab Armor

Frame.

Secure the studs with the pro-

vided 3/8” flat washers, lock washers,

and hex nuts.

NOTE: The hex nuts should only be

finger-tight at this time.

3.) Align the slotted tabs on the top and

bottom of the forward side of the armor

frame with the mating slotted tabs on the

Door Support Frame.

Use the provided

3/8” bolts, flat washers, and metal lock-

nuts to secure the tabs.

TB 9-2320-302-13&P-2

0038 00-39