TB-9-2320-302-13-P-2

CREW PROTECTION KIT PART 2 OF 3

TECHNICAL BULLETIN; OPERATOR'S, UNIT AND DIRECT SUPPORT, MAINTENANCE MANUAL, INSTALLATION INSTRUCTIONS AND REPAIR PARTS AND SPECIAL TOOLS LIST

JUNE 2007

TB-9-2320-302-13-P-2 - Page 243 of 396

ArmorWorks

7.) Place two 2X4’s across truck frame and place armor

on the supports

8.) Guide armor with the two support beams and align in the middle of the underbody

so bolts on the panels under passenger and driver side align with the middle ar-

mor panel. Add nuts, flat washers and lock washers.

9.) Insert shifter cables if removed earlier and slowly Jack truck up

again and remove 4X4 block

10.) Slowly lower cab down with jack (or overhead crane if used)

11.) Reinstall nuts on rear vibration mount and tighten. If needed trim the back corner

between the brackets.

6.) Bolt armor under driver and passenger sides

TB 9-2320-302-13&P-2

0038 00-31