TB-9-2320-335-13-P
TRUCK, UTILITY: EXPANDED CAPACITY, IAP/ARMOR READY
TECHNICAL BULLETIN; OPERATOR AND FIELD MAINTENANCE AND REPAIR PARTS AND SPECIAL TOOLS LIST (RPSTL) INSTRUCTIONS
MAY 2008
TB-9-2320-335-13-P - Page 240 of 680
8-20
TB 9-2320-335-13&P
7.
Apply sealing compound to three capscrews (12).
8.
Install steering gear (14) on frame (13) with three washers (10), lockwashers (11), bracket (9), and
capscrews (12). Tighten capscrews (12) to 160–195 lb-ft (217–264 N
•
m).
9.
Install idler arm (21) on frame (20) with two washers (22), capscrews (23), washers (18), and
locknuts (19). Tighten capscrews (23) to 85 lb-ft (115 N
•
m).
10.
Install two tie rods (26) on center link (17) with two slotted nuts (25). Tighten slotted nuts (25) to
70 lb-ft (95 N
•
m).
11.
Install two cotter pins (24) on slotted nuts (25).
12.
Align hole in yoke (16) with notch on steering gear splines (15) and slide lower steering shaft (3) on
steering gear splines (15).
13.
Install lower steering shaft (3) on steering gear (14) with washer (4), capscrew (6), washer (2), and
lower steering shaft locknut (1). Tighten locknut (1) to 40–50 lb-ft (54–68 N
•
m).
14.
Install two power steering lines adapters (7) on steering gear (14).
15.
Install two power steering lines (5) and O-rings (8) on two adapters (8).
4
6
10
11
12
7
8
14
8
7
1
2
3
5
13
~
15
16
9
8-20.1. STEERING GEAR, CENTER LINK, AND PITMAN ARM REPLACEMENT
(SERIAL NUMBERS 246890 AND ABOVE) (Cont’d)
Back to Top
